Dell Emulex Family of Adapters - Manual (Page 1439)

Boot for the Fibre Channel Protocol User Manual P010096-01A Rev. A
5. OpenBoot
Functional Commands
1439
set-max-lun
set-post-linkup
OpenBoot Signature
Target ID can be bound to either DID (destination ID) or WWPN (worldwide port
name) and saved in an adapter NVRAM. It can also be saved in an environmental
variable boot-device.
Syntax
set-max-lun
Description Shows the current maximum LUN support. Changes and sets the
support setting, the default max lun is 256.
Parameters 0=Set Max Lun to 255 (Default)
1=Set Max Lun to 1023
2=Set Max Lun to 2047
3=Set Max Lun to 4095
Syntax
set-post-linkup
Description Controls if a linkup is to occur during a POST. The default is off.
Parameters 0=Set Linkup Switch OFF (Default)
1=Set Linkup Switch ON
Table 5-1 OpenBoot Signature Table
Signature OpenBoot signature
Valid_flag internal flag for OpenBoot
Host_did shows host DID number
Enable_flag internal flag for OpenBoot
Topology_flag topology flag for OpenBoot
Link_Speed_Flag set link speed
Diag_Switch set fcode diag switch
Boot_id shows target ID number
Lnk_timer internal use for OpenBoot
Plogi_timer internal use for OpenBoot
LUN shows boot LUN in use
DID shows boot ID in use
WWPN shows boot WWPN in use