Dell Emulex Family of Adapters - Manual (Page 524)

OneCapture™ User Manual P010073-01A Rev. A
2. Running OneCapture
Running OneCapture on Linux, Citrix, FreeBSD, and Solaris
524

Basic – The default selection. Select Basic if you do not need to use another type
of capture.

Safe – Use Safe if you are capturing data on a Boot from SAN system.

Full – Includes all available captures, but requires a system and adapter reboot.
Use only if needed.

Custom – Automatically selected when you do a custom pick of components to
capture in the checkbox list.
4. Click Capture. OneCapture gathers the needed information and outputs the file to
the specified folder.
5. After OneCapture is finished running, click Finish on the popup window to close
OneCapture and view the results.
Running OneCapture on Linux, Citrix, FreeBSD, and
Solaris
For Linux, Citrix and Solaris systems, if the OneCommand Manager application was
not installed before running OneCapture, OneCapture will prompt you to install the
basic ocmcore service (OneCapture_Linux_ocmcore.sh). The service is used during the
dump procedure, and is removed after execution.
If the OneCommand Manager application was not installed or allowed, only a
degraded capture is available.
Refer to the OneCommand Manager Application User Manual, available from the Emulex
website, for installation instructions.
Two distributions are included for Linux, Citrix, and Solaris OneCapture.
OneCapture_Linux_10.0.623.0.tgz (OneCapture_Linux.sh)
OneCapture_Linux_ocmcore_10.0.623.0.tgz (OneCapture_Linux_ocmcore.sh)
or
OneCapture_Solaris_10.0.623.0.tgz (OneCapture_Solaris.sh)
OneCapture_Solaris_ocmcore_10.0.623.0.tgz
(OneCapture_Solaris_ocmcore.sh)
One is the general executable file and the other is the ocmcore service embedded
executable file.
Use OneCapture_FreeBSD.sh for FreeBSD systems.
Note: FreeBSD systems do not support the OneCommand Manager application,
therefore OneCapture does not collect the OneCommand Manager application
related data, but OneCapture can collect firmware core dumps.
To run OneCapture on Linux, Citrix, FreeBSD, and Solaris:
1. Copy the script file onto the system through SSH (Secure Shell) or use any other
method.
2. Run the shell script for corresponding systems, for example:
./OneCapture_Linux_ocmcore.sh