Configuring boot mode, Figure 11-3, E “configuring boot mode” on – Dell Emulex Family of Adapters User Manual
Page 1629
Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual
P010097-01B Rev. A
11. Configuring UEFI for Ethernet
Starting the Emulex NIC Configuration Utility
1629
To enable Advanced Mode support:
Note: Changing the Advanced Mode setting requires a reboot.
1. On the Emulex NIC Selection Screen, select Advanced Mode and press <Enter>.
The Advanced Mode pop-up menu appears.
2. Select Enable and press <Enter>.
3. Reboot the system.
Configuring Boot Mode
This setting configures the boot mode.
Enable – iSCSI hardware initiator boot mode
Disable – iSCSI software initiator boot mode
Note: When boot mode is disabled, the iBFT Configuration menu is available.
To configure boot mode:
1. On the Emulex NIC Selection Screen (Figure 11-2), select Boot Mode and press
<Enter>. The Boot Mode pop-up menu appears.
Figure 11-3 Boot Mode Pop-up Menu
2. Select Enable or Disable and press <Enter>.