Description of mandatory and optional parameters, Table b-1, Examples – Dell Emulex Family of Adapters User Manual
Page 723
Emulex Drivers for Windows User Manual
P010077-01A Rev. A
Appendix B. Configuring iSCSI through DHCP
Dynamic Host Configuration Protocol (DHCP) Recommendations
723
Description of Mandatory and Optional Parameters
Table B-1 describes the parameters used in the data string for option 43.
Examples
The following is an example of default initiator name and data digest settings:
iscsi:"192.168.0.2":"3261":"000000000000000E":"iqn.2009-4.com:12345
67890"::"E"::"E"
Target IP address: 192.168.0.2
Target TCP port: 3261
Target boot LUN: 0x0E
Target iqn name: iqn.2009-04.com:1234567890
Initiator name: Not specified. Use the initiator name that is already configured,
or use the default name if no initiator name is already configured.
Header digest: Enabled
Data digest: Not specified; assume disabled.
Authentication type: One-way CHAP.
Table B-1 Data String Parameters for Option 43
Parameter
Description
Field Type
<TargetIP>
A valid IPv4 address in dotted decimal notation
Mandatory
<TargetTCPPort>
A decimal number ranging from 1 to 65535 (inclusive).
The default TCP port is 3260.
Optional
<LUN>
A hexadecimal representation of the LUN of the boot
device. By default, LUN 0 is assumed to be the boot
LUN. It is an eight-byte number which should be
specified as a hexadecimal number consisting of 16
digits, with an appropriate number of zeroes padded to
the left, if required.
Optional
<TargetName>
A valid iSCSI name of up to 223 characters.
Mandatory
<InitiatorName>
A valid iSCSI iqn name of up to 223 characters. If it is
not provided, the default initiator name (generated by
the UCNA based on its MAC address) is used.
Optional
<HeaderDigest>
Either E (the header digest is enabled) or D (the header
digest is disabled).
Optional
<DataDigest>
Either E (the data digest is enabled) or D (the data
digest is disabled).
Optional
<AuthenticationType>
D (authentication is disabled), E (one-way CHAP is
enabled; the user name and secret must be specified by
non-DHCP means), or M (mutual-CHAP is enabled; the
user name and passwords must be specified by
non-DHCP means). D is the default setting.
Optional