Dell Emulex Family of Adapters - Manual (Page 373)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
iSCSI Commands
373
Parameters
AddiSNSServer
This command adds a new iSNS server to the existing set of iSNS servers. It accepts
either an IPv4 or IPv6 server addresses.
Note: For OCe11000-series and OCe11100-series adapters, only one iSNS server can be
configured. For OCe14000-series adapters, up to four iSNS servers can be
configured.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
AddiSNSServer <MAC_Address> <Server_IP> <Port>
Parameters
AddRouteTableEntry
This command adds a new route table entry to the route table of the specified port.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
AddRouteTableEntry <MAC_Address> <Dest_IP_Address> <Subnet_Mask>
<Gateway>
Parameters
MAC_Address
The MAC address of the iSCSI port.
Dest_MAC_Address
The destination MAC address to add to the ARP table.
Dest_IP_Address
The destination IP address to add to the ARP table.
MAC_Address
The MAC address of an iSCSI port.
Server_IP
IP address of the iSNS server to configure.
Port
Port number of the iSNS server to configure (value: 1024–65535).
MAC_Address
MAC address of an iSCSI port.
Dest_IP_Address
Destination IP address to add to the route table.
Subnet_Mask
Subnet Mask to add to the route table.
Gateway
Gateway to add to the route table.