Dell Emulex Family of Adapters - Manual (Page 1532)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
2. Configuring PXE Boot for NIC on LPe16202, OCe10100, and OCe11100-series Adapters
Using the PXESelect Utility
1532
When configuring multichannel on adapters that support IBM Virtual Fabric and
UFP modes, the configuration screen will depend on the Multichannel Mode that
has been selected.
Note: For illustration purposes, the screen displays in this section are for a system
with IBM Virtual Fabric Mode enabled.
Figure 2-13 IBM Virtual Fabric Mode Configuration Screen
Notes:

Logical Link Status is displayed as “N/A” for storage functions.

SR-IOV support can only be enabled if multichannel support is disabled.

If your system does not support some of the multichannel options, those
unavailable options are displayed as N/A on the MultiChannel Configuration
screen.

The SVID, or Outer VLAN ID, is displayed in IBM Virtual Fabric Mode and IBM
Unified Fabric Protocol Mode. This value is provided by the IBM switch and
will appear when the protocol modes are configured on the switch and the
adapter. If the protocol modes are not configured, a value of “N/A” is
displayed.
2. From the configuration screen, you can perform the following tasks:

Configure PXE boot support – see “Configuring PXE Boot Support” on
page 1525 for instructions.

Configure PXE VLAN ID/Priority – see “Configuring the PXE VLAN ID and
Priority” on page 1526 for instructions.

Identify ports – see “Physically Identifying the Port” on page 1527 for
instructions.

Erase the port and adapter configuration – see “Erasing Ports and Controller
Configuration” on page 1527 for instructions.

Configure the LPVID for each channel – see “Configuring LPVID” on page 1529
for instructions.