Setdumpdirectory – Dell Emulex Family of Adapters User Manual
Page 1379
OCM for VMware vCenter Version 10.2 User Manual
P009805-01A Rev. A
11. Using OneCommand Manager for VMware vCenter Command Line Interface
The Command Reference
1379
setdriverparamdefaults <WWPN | MAC> <Flag1> <Flag2>
Description
This command restores the driver parameter to the default value at the port or global
level, either permanently or temporarily for the specified port.
Parameters
setdumpdirectory
Syntax
elxvcpcmd.exe v=<vcenter_server> u=<vc_username> p=<vc_password> h=<esx_host>
setdumpdirectory <WWN | MAC> <DumpDirectory>
Description
Use the setdumpdirectory command to set the dump directory for a given FC/FCoE,
NIC or iSCSI port. To use the SetDumpDirectory command, you must have a directory
mapped under /vmfs/volumes/ where the files will be placed.
Note: The dump directory applies to all adapters in the server. There is no separate
dump directory for each adapter.
Parameters
v
The vCenter server IP address.
u
The user name for the vCenter server.
p
The user password for the vCenter server.
h
The IP address of the ESXi host with Emulex adapters.
WWPN
The WWPN of a port on the ESXi host with Emulex adapters.
MAC
The MAC address of the NIC port.
Flag1
L = Local (all adapters on this host)
G = Global (all adapters on this host)
Flag2
P = Permanent (persists across re-boot)
T = Temporary.
v
The vCenter server IP address.
u
The user name for the vCenter server.
p
The user password for the vCenter server.
h
The IP address of the ESXi host with Emulex adapters.
WWPN
The WWPN of a port on the ESXi host with Emulex adapters.
MAC
The MAC address of the NIC port.
DumpDirectory
The directory under /vmfs/volumes that you created to store the
dump files.