Configuring port options, Setting the configured port speed, Configuring wake on lan – Dell Emulex Family of Adapters User Manual
Page 1799: Figure h-9
Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual
P010097-01B Rev. A
Appendix H. Configuring PXE Boot for NIC on Dell OCe14000-based Systems
Setting Up a PXE Bootable Network
1799
Configuring Port Options
To view the Port Configuration screen:
1. From Port Menu (Figure H-4), select 3. Port Configuration and press <Enter>. The
Port Configuration screen appears.
Figure H-9 Port Configuration Screen
2. From the Configure Partition screen, you can perform the following tasks:
Set the configured port speed – see “Setting the Configured Port Speed” on
page 1799 for instructions.
View the physical link speed and link status.
Configure Wake on LAN (WoL) – see “Configuring Wake on LAN” on
page 1799 for instructions.
Configure flow control – see “Configuring Flow Control” on page 1800 for
instructions.
Configure PXE VLAN, including the PXE VLAN ID and priority – see
“Configuring the PXE VLAN ID and Priority” on page 1800 for instructions.
Identify the port – see “Physically Identifying the Port” on page 1800 for
instructions.
Setting the Configured Port Speed
To set the port speed:
1. On the Port Configuration screen, use the left or right arrow keys to select Auto
Negotiated, 10G, or 1G for the Configured Port Speed setting.
2. Press <F7> to save.
Configuring Wake on LAN
To configure Wake on LAN:
1. From the Port Configuration screen, use the left or right arrow keys to enable or
disable the Wake on LAN setting.
2. Press <F7> to save.