Dell Emulex Family of Adapters - Manual (Page 330)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
Adapter License Management Commands
330
2. For protocol priorites (fcoepriority, iscsipriority, rocepriority), the
valid range is 0 to 7. Only one priority can be specified for each
invocation of this this command and must be for a protocol running on the
port. If more than one protocol priority can be set, they should be unique
values.
3. For the following parameters, valid values are 0 (for disable) and
1 (for enable):
DcbxState, DcbxMode, TxState, RxState, TxPortDesc, TxSysDesc, TxSysName,
TxSysCap, PfcEnable
4. For PfcPriority, separate each priority by a comma (e.g. 3,4,6).
5. Specifying "defaults" for the Param argument sets all DCB parameters
(including Priority Groups) to their default values.
Ex: SetDCBParams <WWPN|MAC> defaults
Adapter License Management Commands
Notes

These commands are only supported on ESXi systems if the CIM provider is
used on a remote system.

Adapter License Management commands are supported on OneConnect
adapters only. They are not available on LPe16202, OCe11101-EM/EX,
OCe11102-EM/EX, or OCe14000 adapters. The following error message will be
returned:
There are no license features for this adapter
In these commands, the WWPN or MAC address argument specifies the adapter the
command is acting upon. The HbaCmd application uses the WWPN or MAC address
to identify the adapter, but this does not mean that the command works successfully on
the specified port.
InstallAdapterLicense
This command installs the license keys from a license file to enable specific features on
the adapter.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
InstallAdapterLicense <WWPN|MAC> <LicenseFile>
Parameters
WWPN
The WWPN of an FCoE port.
MAC
The MAC address of a NIC or iSCSI port.
License File
The path to the license key file containing the license keys obtained
from the Emulex License website.