Dell Emulex Family of Adapters - Manual (Page 336)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
Authentication Commands
336
Parameters
Authentication Commands
These commands are used to configure a DHCHAP connection between an FC port and
a switch port.
Note: Authentication commands are supported on FC adapter ports only. These
commands are not available on OneConnect or LPe16000 family adapters.
AuthConfigList
This command returns the list of WWPNs that have an authentication connection
configuration with the specified adapter.
Supported By
Linux, Solaris, and Windows
Syntax
AuthConfigList <WWPN>
Parameters
DeleteAuthConfig
This command deletes the authentication configuration on the adapter.
Supported By
Linux, Solaris, and Windows
Syntax
DeleteAuthConfig <WWPN1> <WWPN2> <PasswordType> <Password>
WWPN
The WWPN of an FC or FCoE port.
MAC
The MAC address of a NIC or iSCSI port.
PortEnabled
The port-enabled state:
0 = Disabled
1 = Enabled
WWPN
The WWPN of an FC port.