Dell Emulex Family of Adapters - Manual (Page 1390)

OCM for VMware vCenter Version 10.2 User Manual P009805-01A Rev. A
11. Using OneCommand Manager for VMware vCenter Command Line Interface
The Command Reference
1390
updateisnsserver
Syntax
elxvcpcmd.exe v=<vcenter_server> u=<vc_username> p=<vc_password>
h=<esx_host> updateisnsserver <MAC> <Server IP> <Port>
Description
This command updates the configured iSNS server. This command requires the server
IP <Server_IP> and port number <Port> of the iSNS server be available to respond to
the iSNS requests.
Parameters
VEPAenable
Note: VEPA is only supported on OCe14000-series NIC ports. For all other adapter
types and port types this feature is undefined, and this command returns the
following error message: Hardware Does Not Support.
Syntax
elxvcpcmd.exe v=<vcenter_server> u=<vc_username> p=<vc_pwd> h=<esx_host>
VEPAenable <MAC Address> <0|1>
Description
The command takes two parameters:

The MAC address is the MAC address of any NIC on the relevant physical port.

The final parameter specifies whether to enable or disable VEPA: 0 is disabled
and 1 is enabled.
Parameters
v
The vCenter server IP address.
u
The user name for the vCenter server.
p
The user password for the vCenter server.
h
The IP address of the ESXi host with Emulex adapters.
MAC
The MAC address of the iSCSI port.
Server_IP
IP address of the iSNS server to configure.
Port
Port number of the iSNS server to configure (value: 1024-65535).
v
The vCenter server IP address.
u
The user name for the vCenter server.
p
The user password for the vCenter server.
h
The IP address of the ESXi host with Emulex adapters.