Dell Emulex Family of Adapters - Manual (Page 702)

Emulex Drivers for Windows User Manual P010077-01A Rev. A
Appendix A. Error and Event Log Information
FC/FCoE Error and Event Logs
702
Local Reject Status Codes
Codes supplied by the Emulex adapter firmware which indicate why a command was
failed by the adapter.
SRB Status Codes
SCSI Request Block status provided by the driver to the operating system based upon
response from SCSI device in the SAN.
ASC/ASCQ
Additional Sense Code/Additional Sense Code Qualifier information can be found in
any SCSI specification document – these codes contain detailed information about the
status/condition of the SCSI device in question.
Table A-10 Local Reject Status Codes
Explanation Code
SEQUENCE TIMEOUT – Possible bad cable/link noise 0x02
INVALID RPI – Occurs when link goes down 0x04
NO XRI – Possible host or SAN problem 0x05
TX_DMA FAILED – Possible host system issue 0x0D
RX_DMA FAILED – Possible host system issue 0x0E
ILLEGAL FRAME – Possible bad cable/link noise 0x0F
NO RESOURCES – Port out of exchanges or logins 0x11
LOOP OPEN FAILURE – FC_AL port not responding 0x18
LINK DOWN – Queued cmds returned at link down 0x51A
OUT OF ORDER DATA – Possible bad cable or noise 0x1D
Table A-11 SRB Status Codes
Explanation Code
ERROR 0x04
BUSY 0x05
TIMEOUT 0x09
SELECTION TIMEOUT 0x0A
COMMAND TIMEOUT 0x0B
BUS RESET 0x0E
DATA OVERUN 0x12