Dell Emulex Family of Adapters - Manual (Page 619)

Emulex Drivers for Windows User Manual P010077-01A Rev. A
3. Configuration
NIC Driver Configuration
619
[Driver] SR-IOV = 0 (Disabled)
[Registry] TCP Checksum Offload (IPv4) = 3 (Rx & Tx Enabled)
[Driver] TCP Checksum Offload (IPv4) = 3 (Rx & Tx Enabled)
[Registry] TCP Checksum Offload (IPv6) = 3 (Rx & Tx Enabled)
[Driver] TCP Checksum Offload (IPv6) = 3 (Rx & Tx Enabled)
[Registry] Transmit = 1 (Enabled)
[Driver] Transmit = 1 (Enabled)
[Registry] Transmit Buffers = 256 (256)
[Driver] Transmit Buffers = 256 (0x100) (256)
[Registry] Transmit CPU = <not set>
[Driver] Transmit CPU = <not set>
[Registry] Transmit Side Scaling = 1 (Enabled)
[Driver] Transmit Side Scaling = 0 (Disabled)
[Registry] UDP Checksum Offload (IPv4) = 3 (Rx & Tx Enabled)
[Driver] UDP Checksum Offload (IPv4) = 3 (Rx & Tx Enabled)
[Registry] UDP Checksum Offload (IPv6) = 3 (Rx & Tx Enabled)
[Driver] UDP Checksum Offload (IPv6) = 3 (Rx & Tx Enabled)
[Registry] VLAN Identifier (802.1q) = 102
[Driver] VLAN Identifier (802.1q) = 102 (0x66)
[Registry] Virtual Machine Queues = 1 (Enabled)
[Driver] Virtual Machine Queues = 1 (Enabled)
[Registry] Wake On LAN = 1 (Enabled)
[Driver] Wake On LAN = 0 (Disabled)
Using Interactive Mode
The occfg.exe program also supports the interactive mode with a set of menus. To start
this utility in interactive mode, run occfg.exe from a command console and do the
following:
1. A list of adapters displays on which to operate. Type either a number of the list or a
substring from any part of the name (for more information, see “Selecting an
Adapter” on page 615).
2. The program prompts for an operation, such as modifying or querying a parameter
value. Follow the prompt.