Dell Emulex Family of Adapters - Manual (Page 450)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
Appendix A. OneCommand Manager Error Messages
450
Appendix A. OneCommand Manager Error
Messages
Table A-1 contains a list of some of the error messages that may be encountered during
an OCM session.
Table A-1 OneCommand Manager Error Messages
Error Message Command(s) Description
Error: Read-only management mode
is currently set on this host. The
requested command is not permitted
in this mode.
Active management commands
that change a property on an
adapter or host. This message is returned when
certain commands are attempted
when the CLI is configured for
read-only mode.
See “CLI in Read-Only Mode May
Cause Error Message” on
page 312.
Error: Read-only management mode
is currently set on this host. The
requested command is not permitted
in this mode.
various The CLI does not allow the
execution of certain commands
when it is configured for read-only
mode. See “CLI in Read-Only Mode
May Cause Error Message” on
page 312.
Not supported.
ChangeWWN If a volatile change is requested
on an adapter that does not
support volatile WWNs, it returns
a “not supported” error.
See “ChangeWWN” on page 447.
There are no license features for
this adapter
ShowLicenseAdapterID
InstallAdapterLicense
ShowAdapterLicenseFeatures Adapter License Management
commands are not available on
OCe11101-EM/EX or
OCe11102-EM/EX adapters. See
“Adapter License Management
Commands” on page 330.
ERROR: HBACMD_GetDumpFile:
RM_GetDumpFile call failed (2)
ERROR: <2>: Not Supported
GetDumpFile Dump files are copied from the
Dump directory of the remote
host to the Dump directory of the
local host. Specifying a local port
identifier for this command
returns an error, since the source
and destination directory are the
same. See “GetDumpFile” on
page 367.
ERROR: <180>: Authentication:
User unknown
All The specified username is not
valid or could not be
authenticated by the system. See
“OneCommand Manager Secure
Management” on page 296 for
more information.