Dell Emulex Family of Adapters - Manual (Page 1336)

OCM for VMware vCenter Version 10.2 User Manual P009805-01A Rev. A
11. Using OneCommand Manager for VMware vCenter Command Line Interface
The Command Reference
1336
Parameters
clearisnsserver
Syntax
elxvcpcmd.exe v=<vcenter_server> u=<vc_username> p=<vc_password>
h=<esx_host> clearisnsserver <MAC>
Description
This command clears the configured iSNS server and disables iSNS target discovery for
a given port. If there is no iSNS server currently configured, this command does
nothing.
Parameters
cmgetparams
Syntax
elxvcpcmd.exe v=<vcenter_server> u=<vc_username> p=<vc_password>
h=<esx_host> cmgetparams <WWPN | MAC>
Description
This command shows the active (booted) mode (NPar or disabled) for the adapter. This
command also shows the channel management state of the adapter, the configured
state of the adapter, the configured channel management mode, which is N/A if
disabled, and available channel management modes. This is followed by a table
showing the port's channels and their channel properties. The Type column in the table
shows which protocol is running on each channel. Because the displayed channels are
based on all physical ports, some adapters show only two or three channels instead of
four because that is all the physical port allows.
h
The IP address of the ESXi host with Emulex adapters.
WWPN
The port’s WWPN.
ReadType
0 = Volatile, 1 = Non-volatile.
v
The IP address of the vCenter server managing the ESXi host.
u
The user name of the vCenter server.
p
The user password for the vCenter server.
h
The IP address of the ESXi host with Emulex adapters.
MAC
The MAC address of the iSCSI port.