Dell Emulex Family of Adapters - Manual (Page 234)

OneCommand™ Manager Application P010066-01A Rev. A
8. Managing Adapters and Ports
OCe14000-Series Adapters
234
Configuring DCB Parameters for FCoE/iSCSI Adapter Ports
The DCB tab displays parameters for FCoE/iSCSI adapter ports.
Note: For adapter ports running only FCoE or only iSCSI, refer to “Configuring DCB
Parameters for FCoE Adapter Ports” on page 158 and to “Configuring DCB
Parameters for iSCSI Adapter Ports” on page 173.
To view the DCB parameters for FCoE/iSCSI adapter ports:
1. From the discovery-tree, select the FCoE/iSCSI adapter port whose DCB properties
you want to view.
2. Select the DCB tab.
Figure 8-87 DCB Tab (FCoE/iSCSI Adapter Port Selected)
DCB Tab Field Definitions

DCBX State – The current DCBX state (enabled or disabled).

LLDP Transmit State – DCBX uses LLDP to exchange parameters between two
link peers. For the DCBX protocol to operate correctly, both LLDP Rx and Tx
must be enabled. If either Rx or Tx is disabled, DCBX is disabled.

LLDP Receive State – DCBX uses LLDP to exchange parameters between two
link peers. For the DCBX protocol to operate correctly, both LLDP Rx and Tx
must be enabled. If either Rx or Tx is disabled, DCBX is disabled.