Dell Emulex Family of Adapters - Manual (Page 1693)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
13. Configuring UEFI for FCoE
Overview
1693
13. Configuring UEFI for FCoE
Note: If you have several adapters in your system, the UEFI system firmware or boot
code uses the highest version driver installed on any of the adapters. Adapters
with older versions of EFIBoot are managed by the more recent version, but
only as long as the adapter with the most recent version is in the system. The
latest firmware and boot code must be installed on each adapter in the system to
ensure that each adapter runs the latest firmware and boot code.
Overview
UEFIBoot supports:

Single-topology – only Fabric point to-point is supported.

EFI protocols – all applicable UEFI 2.3 driver protocols are supported.

Operating systems – all UEFI-aware operating systems are supported.

Multi-Device path – fibre/SCSI device path is selectable through the driver
configuration application.

Multi-initiators – up to 256 ports are supported.

Multi-boot – eight targets are selectable through the driver configuration
application.

Multi-LUNs – up to 4096 LUNs are supported.

Multi-utility – setup and firmware updates are supported.
The Emulex FCoE UEFIboot is loaded from flash into system memory.
To verify that the Emulex UEFIBoot driver is loaded, enter the EFI Shell, type
“
drivers
”, and then press <Enter>.
Note: If you are using Dell adapters, refer to appendix F., “Dell UEFI,” on page 1762
for information on using the Dell UEFI utility.
Navigating the Emulex FCoE Configuration Utility
The Emulex FCoE configuration utility has menus and configuration screens. Use the
following methods to navigate them:

Press the up/down arrows on your keyboard to move through and select menu
options or configuration fields. When multiple adapters are listed, use the
up/down arrows to scroll to the additional adapters.

Press the <+>, <->, or <Enter> keys to change numeric values.

Press <Enter> to select a menu option, to select a row in a configuration screen,
or to change a configuration default.

Use the navigation entries on the page to move about the utility.

Press <Esc> to exit the current screen and show the previous screen.

Select Commit to save changes. Select Discard to not save changes.