Initiateauth, Setauthconfig – Dell Emulex Family of Adapters User Manual
Page 338
OneCommand Manager Command Line Interface Version 10.2 User Manual
P010067-01A Rev. A
5. CLI Client Command Descriptions
Authentication Commands
338
InitiateAuth
This command initiates the authentication configuration on the adapter.
Supported By
Linux, Solaris, and Windows
Syntax
InitiateAuth <WWPN1> <WWPN2>
Parameters
SetAuthConfig
This command sets the authentication configuration for the adapter.
Supported By
Linux, Solaris, and Windows
Syntax
SetAuthConfig <WWPN1> <WWPN2> <PasswordType> <Password> <Param> <Value>
Note: Where multiple parameters and values are used, separate them using commas.
Parameters
WWPN1
The WWPN of an FC port.
WWPN2
Use “ff:ff:ff:ff:ff:ff:ff:ff” for a switch or use the WWPN for a target.
WWPN1
The WWPN of an FC port.
WWPN2
Use “ff:ff:ff:ff:ff:ff:ff:ff” for a switch or use the WWPN for a target.
PasswordType
1 = ASCII
2 = Hex (binary)
3 = Password not yet defined
Password
The current password value.
Param
The parameter names:
Mode
Timeout
Bi-directional
Hash-priority
DH-priority
Re-authentication
Re-authentication-interval