Dell Emulex Family of Adapters - Manual (Page 926)

Emulex Drivers Version 10.2 for Linux User Manual P010081-01A Rev. A
4. Troubleshooting
Log Messages
926
1211: genreq alloc failed\n");
Resource allocation failure.
Data: (1) return code
Log: LOG_LIBDFC
Severity: Error
Action:
Kernel memory resources too low.
1213: FCoE cmd overflow: off <#> + cnt <#> > cmdsz <#>
Application has tried to read more data than originally requested.
Data: (1) response offset (2) size (3) cmd size
Log: LOG_LIBDFC
Severity: Error
Action:
Application may have sent a invalid command.
1214: Cannot issue FCoE cmd SLI not active: <#> rc= -EACCESS
The SLI layer has not been initialized.
Data: (1) offset
Log: LOG_LIBDFC
Severity: Error
Action:
Restart the HBA.
1215: Cannot issue FCoE cmd: not ready or not in maint mode"
Either the external link is unplugged, link down, and the FCoE is not in maintenance mode.
Data: (1) current offset (2) return code.
Log: LOG_LIBDFC
Severity: Error
Action:
Plug external cable in or set FCoE in maintenance mode.
1216: FCoE IOCB failed: off <#> rc <#>
FCoE command generated by the application has failed.
Data: (1) offset (2) return code.
Log: LOG_LIBDFC
Severity: Error
Action:
Application should retry the command.
1223: menlo_write: couldn't alloc genreq
Resource allocation failure.
Data: None
Log: LOG_LIBDFC
Severity: Error
Action:
Kernel memory resources too low.
1224: FCoE iocb failed off <#> rc=<#>",
FCoE command failed in SLI.
Data: (1) offset (2) return code
Log: LOG_LIBDFC
Severity: Informational.
Action:
Retry the command, if it fails again, reset HBA when convenient.
Table 4-4 LPFC Error Log Messages and their Descriptions (Continued)