Dell Emulex Family of Adapters - Manual (Page 404)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
Miscellaneous Commands
404
Parameters
Reset
This command resets the adapter. An adapter reset can require several seconds to
complete, especially for remote devices. When the reset is completed, the system
command prompt is displayed.
Notes

Supported for FC and FCoE ports only.

For OneConnect and LPe16202 FCoE ports, this command only resets the driver
to update changed driver parameters that require a driver reset. It does not
cause a hardware reset of the adapter port.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
Reset <WWPN>
Parameters
SetCimCred
This command sets the default CIM credentials. You must specify all four credentials:
username, password, namespace, and port number. Default credentials are used if any
credential is not in the hbacmd command argument. Once the default credentials for a
host are set, any other command can be issued by specifying “m=cim”.
Supported By
Windows
Syntax
SetCimCred <username> <password> <namespace> <portnum>
Note: Use this command to set only the CIM credentials. Once this is done,
subsequent hbacmd commands do not require you to specify the CIM
credentials in the command line.
host_address
The host to remove.
IP_Address
The IP address of the host to remove.
WWPN
The WWPN of an FC or FCoE port.