Dell Emulex Family of Adapters - Manual (Page 1660)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
11. Configuring UEFI for Ethernet
Erasing Ports and Controller Configuration
1660
Note: If port identification is not supported on your system, you will receive a
message stating that it is not supported.
Erasing Ports and Controller Configuration
Note: When selecting this setting, all previous configuration settings are returned to
their factory default settings except for the current personality selection. Emulex
recommends performing this action to provide a clean environment for new
configuration settings to take effect.
To erase ports and the controller configuration:
1. On the Emulex NIC Selection Screen, select Erase Configuration and press
<Enter>.
A warning appears asking if you want to erase the configurations for both ports of
the controller.
Figure 11-29 Erase Configuration Screen
2. Press <Enter> to delete the controller configuration, or press <Esc> to abort the
operation.