Dell Emulex Family of Adapters - Manual (Page 1438)

Boot for the Fibre Channel Protocol User Manual P010096-01A Rev. A
5. OpenBoot
Functional Commands
1438
Functional Commands
.remove-boot-id
set-default-mode
set-link-speed
Note: The Link Speed setting will be overwritten by the FC driver and will not take
effect during a regular boot into the local OS. Therefore, setting the link speed
from the BIOS utility should only be used with boot from SAN.
Syntax
.remove-boot-id
Description Removes the boot ID from the boot list.
"/pci@1f,0/pci@1/lpfc@1" select-dev
remove-boot-id /* to clear boot id settings */
unselect-dev
or
"/pci@1f,0/pci@1/lpfc@1" select-dev
set-default-mode /* to clear boot id settings */
unselect-dev
Parameters None
Syntax
set-default-mode
Description Resets to the default value mode.
Parameters None
Syntax
set-link-speed
Description Shows the current link-speed setting. Changes and sets the link speed.
The default is 0=Auto Select Link Speed.
Parameters 0=Auto Select Link Speed (Default)
1=1 Gb/s Link Speed – Only
2=2 Gb/s Link Speed – Only
4=4 Gb/s Link Speed – Only
8=8 Gb/s Link Speed – Only
16=16 Gb/s Link Speed – Only