Dell Emulex Family of Adapters - Manual (Page 360)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
Diagnostic Commands
360
Base Address 0: 0x00000000 Base Address 1: 0xDF478000
Base Address 2: 0xDF480004 Base Address 3: 0x00000000
Base Address 4: 0xDF4A0004 Base Address 5: 0x00000000
CIS: 0x00000000 SubVendor ID: 0x10DF
SubSystem ID: 0xE622 ROM Base Address: 0x00000000
Interrupt Line: 0x00 Interrupt Pin: 0x01
Minimum Grant: 0x00 Maximum Latency: 0x00
Capabilities Ptr: 0x40
PostTest
Note: Not supported for OneConnect and LPe15000 or LPe16000 series adapters.
This command runs the POST on the adapter.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
PostTest <WWPN>
Parameters
SetBeacon
This command turns the beacon on or off.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
SetBeacon <WWPN> <BeaconState>
Parameters
WWPN
The WWPN of the FC port.
WWPN
The WWPN of an FC port.
MAC
The MAC address of a NIC or iSCSI port.
BeaconState
Indicates the state of the beacon to be set to value:
0 = Off
1 = On