Dell Emulex Family of Adapters - Manual (Page 1614)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
10. Configuring and Managing iSCSI Targets with the iSCSISelect Utility
Managing an iSCSI Target
1614
12. Select Yes from the Data Digest pop-up menu if you want to enable Data Digest.
When set to Yes, and the iSCSI initiator is set accordingly, the integrity of an iSCSI
PDU’s data segment is protected by CRC32C checksum. The default setting is No.
13. Select the Authentication Method. For more information, see “Enabling CHAP
Authentication” on page 1616.
14. Select Save/Login and press <Enter>. If the firmware logs into the target
successfully, you receive a successful login message. Press <Esc> to go to the iSCSI
Target Configuration menu where you can view information about the added
target.
15. To enable Boot Target or make any other changes to your target or targets, select the
target and press <Esc>.
Managing an iSCSI Target
With the iSCSISelect utility you can manage a target by viewing target details or by
editing the target configuration.
Viewing Target Information
After you have successfully logged into the target, you can view the details of the
newly-added target or manage the target. From the Controller Configuration menu,
select iSCSI Target Configuration and press <Enter> to view the target information.
Note: The iSCSISelect utility only shows LUN information for the first 128 LUNs.
The following is an example of a target detail.
Figure 10-5 iSCSI Target Configuration Information
In the iSCSI Target Configuration menu, the functions keys located at the bottom of the
menu help you manage your target configuration.

Press <Enter> to select the target configuration.

Press <Del> to delete the target.

Press <F5> to log in to the target.

Press <F6> to log out of the target.

Press <F7> to configure the LUN.

Press <Esc> to return to the previous menu.