Dell Emulex Family of Adapters - Manual (Page 906)

Emulex Drivers Version 10.2 for Linux User Manual P010081-01A Rev. A
4. Troubleshooting
Log Messages
906
0424:lpfc_"#attr" attribute cannot be set to %d, allowed range is ["#minval",
"#maxval"]
This is a compile time macro that is used by several module parameters to set the value.
Data: None
Severity: Error
Log:
LOG_INIT
Action: Set the module parameter between the minimum and maximum values.
0425:lpfc_restrict_login attribute cannot be set to %d, allowed range is [0, 1]
The module parameter lpfc_restrict_login can only be set to 0 (off) or 1 (on).
Data: None
Severity: Error
Log:
LOG_INIT
Action: Set lpfc_restrict_login=[0,1].
0426: Failed to enable interrupt
The driver failed to start the interrupt.
Data: None
Severity: Error
Log:
LOG_INIT
Action: Unload and reload the driver.
0427: Cannot re-enable interrupt after slot reset
The driver was unable to enable the interrupt after an HBA reset.
Data: None
Severity: Error
Log:
LOG_INIT
Action: Unload and reload the driver.
0429: MSI-X fast-path request_irq failed (<rc>)
The driver received an error for the request_irq_call.
Data: None
Severity: Warning
Log:
LOG_INIT
Action: Unload and reload the driver.
0430: PM resume Failed to enable interrupt
The driver’s power management resume function could not enable the interrupt.
Data: None
Severity: Error
Log:
LOG_INIT
Action: Perform another PM suspend and resume or HBA reset.
0431: Failed to enable interrupt.
The driver failed to start the interrupt.
Data: None
Severity: Error
Log:
LOG_INIT
Action: Unload and reload the driver.
Table 4-4 LPFC Error Log Messages and their Descriptions (Continued)