Dell Emulex Family of Adapters - Manual (Page 889)

Emulex Drivers Version 10.2 for Linux User Manual P010081-01A Rev. A
4. Troubleshooting
Log Messages
889
0268: NS cmd <cmdcode> Error (<ulpStatus> <un.ulpWord[4]>)
The NameServer CT request failed.
Data: None
Severity: Error
Log:
LOG_DISCOVERY
Action: Check the port and switch configurations.
0271: Illegal State Transition: node <nlp_DID> event <evt>, state <nlp_state>
Data: <nlp_rpi> <nlp_flag>
The current node state does not have a handler for this event.
Data: (1) nlp_rpi (2) nlp_flag
Severity: Error
Log:
LOG_DISCOVERY
Action: Verify that all targets are still visible to the SCSI mid-layer.
0272: Illegal State Transition: node <nlp_DID> event <evt>, state <nlp_state>
Data: <nlp_rpi> <nlp_flag>
The driver is completing a PLOGI but do not have the rcv_plogi flag set.
Data: (1) nlp_rpi (2) nlp_flag
Severity: Error
Log:
LOG_DISCOVERY
Action: Verify that all targets are still visible to the SCSI mid-layer.
0273: Unexpected discovery timeout, vport State x%x
The discovery process has timed out.
Data: None
Severity: Error
Log:
LOG_DISCOVERY
Action: Verify that all targets are still visible.
0274: lpfc_nlp_put: ndlp:x%pusgmap:x%x refcnt:%d, void *)ndlp,
ndlp->nlp_usg_map, atomic_read(&ndlp->kref.refcount)
Data: None
Severity: Warning
Log:
LOG_NODE
Action: None required.
0275: lpfc_nlp_put: ndlp:x%pusgmap:x%x refcnt:%d, void *)ndlp,
ndlp->nlp_usg_map, atomic_read(&ndlp->kref.refcount)
A kref_put was called again after the node was already inactive.
Data: None
Severity: Warning
Log:
LOG_NODE
Action: None required.
0276: lpfc_nlp_get: ndlp:x%pusgmap:x%x refcnt:%d, void *)ndlp,
ndlp->nlp_usg_map, atomic_read(&ndlp->kref.refcount)
A kref_get was attempted on a node that was being released.
Data: None
Severity: Warning
Log:
LOG_NODE
Action: None required.
Table 4-4 LPFC Error Log Messages and their Descriptions (Continued)