Dell Emulex Family of Adapters - Manual (Page 936)

Emulex Drivers Version 10.2 for Linux User Manual P010081-01A Rev. A
4. Troubleshooting
Log Messages
936
1477: Failed to set up hba
Failed to set up the HBA.
Data: None
Severity: Error
Log:
LOG_INIT
Action: None required.
1603: Loopback test did not receive expected data length. actual length
<len>expected length <full_size>.
The loopback test did not receive the same amount of data that it transmitted.
Data: None
Severity: Error
Log:
LOG_LIBDFC
Action: None required.
1800: Could not issue unreg_vpi
Driver attempt to unregister VPI failed.
Data: None
Severity: Error
Log:
LOG_VPORT verbose
Action: Software driver error. If this issue persists, report these errors to Technical Support.
1801: Create vport work array FAILED: cannot do scsi_host_get
The driver was unable to get a reference to a SCSI host.
Data: None
Severity: Warning
Log:
LOG_VPORT verbose
Action: Software driver warning. If this issue persists, report these errors to Technical Support.
1816: FLOGI NPIV supported, response data <port>
The fabric reports support for NPIV upon FLOGI.
Data: (1) response_multiple_NPort
Severity: Warning
Log:
LOG_VPORT verbose
Action: No action needed, informational.
1817: Fabric does not support NPIV - configuring single port mode
The fabric reports no support for NPIV upon FLOGI.
Data: None
Severity: Warning
Log:
LOG_VPORT verbose
Action: No action needed, informational.
1818: VPort failed init, mbxCmd <mailbox command> READ_SPARM mbxStatus <mailbox
status> , rc = <status>
A pending mailbox command that was issued to initialize the port failed.
Data: (1) mbxCommand (2) mbxStatus (3) rc
Severity: Error
Log:
LOG_VPORT verbose
Action: Software driver error. If this issue persists, report these errors to Technical Support.
Table 4-4 LPFC Error Log Messages and their Descriptions (Continued)