Dell Emulex Family of Adapters - Manual (Page 1526)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
2. Configuring PXE Boot for NIC on LPe16202, OCe10100, and OCe11100-series Adapters
Using the PXESelect Utility
1526
Configuring SR-IOV
If your system BIOS supports SR-IOV, you can enable it on the adapter. SR-IOV
support can only be enabled when multichannel is disabled or not supported. For more
information on SR-IOV configuration, see the appropriate Emulex driver manual.
To configure SR-IOV:
1. On the configuration screen, use the <Tab> key to select the SR-IOV setting and a
pop-up menu appears.
2. Select Enabled or Disabled and press <Enter>.
3. Select Save and press <Enter>.
Configuring the PXE VLAN ID and Priority
To configure a PXE VLAN ID and set the priority level:
1. On the configuration screen, select Configure PXE VLAN ID/Priority and press
<Enter>. The Configure PXE VLAN ID/Priority menu is displayed.
Figure 2-9 Configure PXE VLAN ID/Priority Menu
2. Use the <Tab> key to select the PXE VLAN Support setting and a pop-up menu
appears.
a. For PXE VLAN Support, select Enabled and press <Enter>.
b. For the PXE VLAN ID, enter a number from 0-4094 and press <Enter>.
c. For the PXE VLAN Priority level, enter a number from 0-7 and press <Enter>.
This unique value assigns a priority to outbound packets containing a specified
VLAN ID. Valid values range from 0-7, with 0 the highest priority level.
3. Select Save and press <Enter>.
After you exit the PXESelect utility, the system will reboot for the configuration to take
effect.