Dell Emulex Family of Adapters - Manual (Page 711)

Emulex Drivers for Windows User Manual P010077-01A Rev. A
Appendix A. Error and Event Log Information
iSCSI Error and Event Log
711
0x33900002 The iSCSI driver failed an I/O request
because it failed to retrieve a scatter
gather list from the Storport driver. This failure occurred due to a failed memory
allocation in the operating system. Check low
memory conditions.
0x31880001 The iSCSI driver failed to load because
initialization failed during a power
management bootup. This failure may be due to the firmware not
being present or currently running. This failure
may also indicate a hardware issue.
0x3184000c The iSCSI driver was unable to map
one or more PCI Base Address
Registers and failed to load. This failure may indicate a low memory
condition or a hardware error.
0x3184000b The iSCSI driver ignored a
configuration entry because the entry
was invalid. The invalid entry must be removed or
corrected. Check the registry configuration for
any new valid values added to the driver
parameters. For more information on valid
driver values, see Table 3-12, iSCSI Driver
Options, on page 662.
0x31840009 The iSCSI driver failed to load a
configuration value specified in the
registry because the value was out of
range. The driver will use the default
value for this configuration parameter
instead. The range specified for a configuration
parameter is too large or too small and must be
corrected. Check the registry configuration for
any new valid values added to the driver
parameters. For more information on valid
driver values, see Table 3-12, iSCSI Driver
Options, on page 662.
0x31840006 The iSCSI driver failed to load due to
memory allocation failure. This failure occurred due to a failed memory
allocation in the driver. Check low memory
conditions.
0x31840001 The iSCSI driver failed to load because
initialization failed during normal
bootup. This failure may be due to the firmware not
being present or currently running. This failure
may also indicate a hardware issue.
0x31640004 An internal API failed in the iSCSI
driver during initialization. This failure may indicate a low memory
condition.
0x3164000D The driver failed to allocate its
complete memory requirement and
will attempt to load with reduced
capabilities. Total number of targets
available will be reduced. This message indicates a low memory
condition.
0x14831000 There was an Unrecoverable Error
detected by the iSCSI driver. Following
this error log entry, the next 3 entries
indicate the error codes. This may be due to hardware errors or due to
unhandled exceptions in the hardware or
firmware.
0x138e0103 The iSCSI driver failed an IOCTL
request because the number of scatter
gather elements required for the
IOCTL buffer exceeded the firmware
limit. Following this error log entry,
the next entry will indicate the IOCTL
opcode and the payload length
requested. This error may indicate an incorrect
configuration option for the iSCSI driver. It may
also indicate a low memory condition.
Table A-14 iSCSI Error Log Entries on Windows Server 2008 (Continued)
Message ID Message Description/Recommended Resolution