Dell Emulex Family of Adapters - Manual (Page 1621)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
10. Configuring and Managing iSCSI Targets with the iSCSISelect Utility
Managing an iSCSI Target
1621
To log out of a target, from the iSCSI Target Configuration screen, select the target and
press <F6>.
To log into a target, from the iSCSI Target Configuration screen, select the target and
the disconnected target, and then press <F5> to establish the target session.
Booting the System
After you have configured the iSCSI initiator and target, you must reboot the system
for the configurations to take effect. When you exit the iSCSISelect utility, the system
automatically reboots and during system startup, the Emulex adapter BIOS is
displayed. For example:
Controller#0 Port#0 Base 0xFCE60000 at Bus:01 Dev:00 Fun:02
Controller#0 Port#1 Base 0xFCEA0000 at Bus:01 Dev:00 Fun:03
<<< Press <Ctrl><S> for iSCSISelect(TM) Utility >>>
Initiator iSCSI Name: iqn.2004-05.com.emulex
Initiator IP Address: 172. 40. 1.41
Initiator IP Address: 172. 40. 1.62
BIOS Not Installed.
Note: The iSCSI BIOS logs into the configured iSCSI boot target and shows its
target/LUN information in the BIOS sign-on banner only if you have
configured an iSCSI boot target. For more information, see “Setting Up a Basic
iSCSI Boot Configuration” on page 1596.