Dell Emulex Family of Adapters - Manual (Page 289)

OneCommand™ Manager Application P010066-01A Rev. A
14. Troubleshooting
Emulex Driver for Linux and OneCommand Manager Application Situations
289
Cannot see new LUNs. Try the following:
1) Click the Refresh LUNs button in the toolbar.
2) Exit the OneCommand Manager application and restart the
OneCommand Manager application. If new LUNs are visible,
you are finished.
If that does not work, try the following:
1) Exit the OneCommand Manager application.
2) Navigate to /usr/sbin/ocmanager.
3) Run ./stop_ocmanager to stop both the elxhbamgr and
elxdiscovery processes.
4) Run ./start_ocmanager and ./start_elxdiscovery to restart
both processes.
5) Start the OneCommand Manager application.
Unwanted remote servers appear in the
OneCommand Manager application. To remove out-of-band (TCP/IP) managed systems:
1) From the main menu, select Discovery-->TCP/IP-->Remove
Host(s)...
2) Select all hosts that you would like to stop discovering.
3) Select Remove.
4) Click Done to exit.
The OCM CLI command to
“GetDriverParamsGlobal” implicitly returns
the permanent (i.e. across reboots) values of
the global driver parameters. The temporary
global value is only returned if there is no
current assignment of the permanent global
value. If you want the current (temporary) value of the adapter driver
parameter, use the “GetDriverParams” command instead of the
“GetDriverParamsGlobal” command.
Table 14-2 Emulex Driver for Linux and OneCommand Manager Application Situations (Continued)
Situation Resolution