Dell Emulex Family of Adapters - Manual (Page 364)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
Driver Parameter Commands
364
SaveConfig
This command saves the specified adapter’s driver parameters to a file. The resulting
file contains a list of driver parameter definitions in ASCII file format with definitions
delimited by a comma. Each definition has the following syntax:
<parameter-name>=<parameter-value>
The command saves either the values of the global set, or those specific to the adapter
in the Emulex Repository directory.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
SaveConfig <WWPN> <FileName> <Flag>
Parameters
SetDriverParam
This command changes a driver parameter and designates the scope of the change.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
SetDriverParam <WWPN> <Flag1> <Flag2> <Param> <Value> <enable-dtm>
Parameters
WWPN
The WWPN of an FC or FCoE port.
FileName
Name of the file that contains the driver parameters list.
Flag
G = Save the global parameter set.
N = Save the local (adapter-specific) parameter set.
WWPN
The WWPN of an FC or FCoE port.
Flag1
L = Make change local for this adapter only.
G = Make change global (all adapters on this host).
Flag2
P = Make change permanent (persists across reboot).
T = Make change temporary.
Param
Name of the parameter to modify.
Value
New parameter value, decimal or hexadecimal (0xNNN).
enable-dtm
P = Make change permanent (persist across reboot).
Note: Dynamic target mode is only supported on Light Pulse FC
HBA COMSTAR ports.