Dell Emulex Family of Adapters - Manual (Page 262)

OneCommand™ Manager Application P010066-01A Rev. A
11. Configuring Boot from an FC SAN
Configuring Advanced Settings (Boot from SAN)
262

100 ms

200 ms

Default AL_PA number – The range is 0x 00-EF. The default is 0x00. This option
changes the AL_PA (Arbitrated Loop Physical Address) of the selected adapter.
(Not available for OneConnect adapters.)
OpenBoot Advanced Adapter Settings Dialog Box
Use this dialog box to configure the Advanced Adapter Settings for the selected
OpenBoot adapter.
Figure 11-5 OpenBoot Advanced Settings Dialog Box
OpenBoot Advanced Adapter Field Definitions

PLOGI Retry Timer – Sets the PLOGI Retry timer value. Range is 0 to 0xFF.

Default AL_PA (hex) – Sets the default AL_PA. The range is 0 to 0xEF. The
default is 0. (Not available for OneConnect adapters.)

Enable the Software Foundation Suite (SFS) – Check to enable the Software
Foundation Suite (SFS) driver (the emlxs driver). The default is the LPFC driver.