Dell Emulex Family of Adapters - Manual (Page 1695)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
13. Configuring UEFI for FCoE
Updating Firmware and Boot Code
1695
The Emulex Adapter Configuration Main Menu is displayed.
Figure 13-3 Emulex Adapter Configuration Main Menu
Note: The DCBX mode is always set to CEE and cannot be configured.
Updating Firmware and Boot Code
To update the firmware and boot code to the latest versions, you must use the NIC
firmware update utility, which revises the FCoE function with a single firmware and
boot code image. For more information on revising firmware versions, see chapter 11.,
“Configuring UEFI for Ethernet,” on page 1625.
Enabling an Adapter to Boot from SAN
To enable an adapter to boot from SAN:
1. From the Device Manager screen (Figure 13-2), select the adapter whose network
boot setting you want to change and press <Enter>.
2. From the Emulex Adapter Configuration Main Menu (Figure 13-3), select Set Boot
from SAN. The current setting is displayed. A Disable/Enable menu is displayed.
Press <Enter>.
3. Select Enable and press <Enter>.The selection is changed to NVRAM and the
current setting is displayed.