Dell Emulex Family of Adapters - Manual (Page 1375)

OCM for VMware vCenter Version 10.2 User Manual P009805-01A Rev. A
11. Using OneCommand Manager for VMware vCenter Command Line Interface
The Command Reference
1375
Parameters
Example:
This command sets the bandwidth of PGID0 to 50 PGID1 to 50 and the rest to 0%.
elxvcpcmd.exe setcnapgbw 10:00:00:00:c9:3c:f7:88 50 50 0 0 0 0 0 0
setdcbparam
Syntax
elxvcpcmd.exe v=<vcenter_server> u=<vc_username> p=<vc_password>
h=<esx_host> setdcbparam <WWPN | MAC> <Param> <Value>
Description
This command configures the DCB and LLDP settings on a UCNA.
Parameters
UCNA Parameters and Values (1= enabled 0 = disabled)
DCBXState – The current DCBX (Data Center discovery and Capability
exchange protocol) state.PFCEnable – Enabled means that flow control in both
directions (Tx and Rx) is enabled.
FCoEPriority – You must specify a single priority (0-7). [only for FCoE adapters]
iSCSIPriority – You must specify a single priority (0-7). [only for iSCSI adapters]
PFCPriorities – Specify PFCPriorities as a single priority or as a list of comma
separated values. Comma separated list of up to 7 values ranging from 0-7.
v
The vCenter server IP address.
u
The user name for the vCenter server.
p
The user password for the vCenter server.
h
The IP address of the ESXi host with Emulex adapters.
WWPN
The WWPN of a port on the ESXi host with Emulex adapters.
MAC
The MAC address of the NIC port.
BW0 to BW7
The bandwidth for priority group 0 to 7.
v
The vCenter server IP address.
u
The user name for the vCenter server.
p
The user password for the vCenter server.
h
The IP address of the ESXi host with Emulex adapters.
WWPN
The WWPN of a port on the ESXi host with Emulex adapters.
MAC
The MAC address of the NIC or iSCSI port.
Param
See below.
Value
See below.