Dell Emulex Family of Adapters User Manual
Page 901
Emulex Drivers Version 10.2 for Linux User Manual
P010081-01A Rev. A
4. Troubleshooting
Log Messages
901
0375: FCP cmdiocb not callback function iotag: <iocb iotag>
The IOCB found for this iotag does not have a completion handler set in it.
Data:
None
Severity: Warning
Log:
LOG_SLI
Action:
None required.
0377: Error <rc> parsing vpd. Using defaults.
Could not parse the VPD data, so the driver is using the default values.
Data:
None
Severity: Error
Log:
Always
Action:
None required.
0378: No support for fcpi mode.
Could not configure the port to run in FCP initiator mode.
Data:
None
Severity: Warning
Log:
LOG_MBOX, LOG_SLI
Action:
None required.
0379: Feature Mismatch Data: <req ftr word2 hex> <req_ftr word3 hex>
<cfg_enable_npiv> <max vpi hex>
The features passed in to the driver as module parameters do not match what the firmware can do.
Setting to default values.
Data:
None
Severity: Warning
Log:
LOG_MBOX, LOG_SLI
Action:
None required.
0381: Error %d during queue setup.
Could not set up all the queues that the driver requires to exchange I/Os with the HBA.
Data:
None
Severity: Error
Log:
LOG_MBOX, LOG_SLI
Action:
Reload the driver.
0382: READ_SPARAM command failed status <issue status>, mbxStatus <mailbox
status>
The READ_SPARAM mailbox command has failed during initialization. The HBA has been set to error
state.
Data:
None
Severity: Error
Log:
LOG_MBOX, LOG_SLI:
Action:
Take a dump with hbacmd and then try reloading the driver.
0383: Error <rc> during scsi sgl post operation
The SGL entries could not be registered with the adapter.
Data:
None
Severity: Warning
Log:
LOG_MBOX, LOG_SLI
Action:
Reset the adapter using hbacmd.
Table 4-4 LPFC Error Log Messages and their Descriptions (Continued)