Dell Emulex Family of Adapters - Manual (Page 1713)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
14. Troubleshooting
Troubleshooting for the NIC Protocol
1713
ARP/TFTP Error Codes
PXE-E11:ARP timeout An ARP request is tried four times
and the client did not receive an
ARP reply. Check the DHCP server settings. If
you are connected through a
switch, also check the switch
settings.
PXE-E32: TFTP Open timeout. A DHCP address and boot file
name has been obtained and
attempts to download the file
name from a remote server. • Check that the TFTP is
configured properly.
• Check that the filename is
properly placed in the tftpboot
directory.
• Check that the PXE server is
configured for TFTP not MTFTP.
PXE-E35: TFTP read timeout. A TFTP server is not able to
receive the next packet. Check that the hardware and TFTP
server are functioning properly.
PXE-E36: Error received from
TFTP server. A TFTP server sends an error
packet. Check the TFTP server settings
and boot file settings.
PXE-E38: TFTP cannot open
connection. A TFTP client is not able to open a
TFTP connection with the TFTP
server. Check that the correct boot file is
copied into the default TFTP boot
path.
PXE-E3B: TFTP error-File not
found A requested boot file is not found
on TFTP server. Check that the correct boot file is
copied into the default TFTP boot
path.
PXE-E3C: TFTP error - Access
violation. The TFTP server does not have
enough access rights to open or
read the file. Check the TFTP server’s file
permissions.
PXE-E3F: TFTP packet size is
invalid TFTP packet received is larger
than 1456 bytes. Check the MTU on the Server side
NIC interface.
Boot/DHCP Error Codes
PXE-E51: No DHCP or Proxy
DHCP offers were received. The client did not receive any
valid DHCP, BOOTP, or Proxy DHCP
offers. Check that the bootfile name is
configured correctly for PXE
Clients in the DHCP setup.
PXE-E52: Proxy DHCP offers
were received. No DHCP offers
were received. The client did receive at least one
valid proxyDHCP offer, but did not
receive any valid DHCP or BOOTP
offers. Check that the DHCP server and
PXE server are configured
properly.
PXE-E53: No boot filename
received. The client did receive a valid
BOOTP/DHCP offer, but does not
have a boot file name to download
in the DHCP offer. Check that the bootfile name is
configured correctly for
PXEClients in the DHCP setup.
Table 14-1 PXE Error Codes (Continued)
Error Codes Possible Reason Comment/Solution