Dell Emulex Family of Adapters - Manual (Page 908)

Emulex Drivers Version 10.2 for Linux User Manual P010081-01A Rev. A
4. Troubleshooting
Log Messages
908
0440: Adapter failed to init, READ_REV has missing revision information
A firmware revision initialization error was detected.
Data: None
Severity: Error
Log:
Always
Action: This error could indicate a hardware or firmware issue. Install the latest firmware
revision. If this issue persists, report the error to Technical Support.
0442: Adapter failed to init, mbxCmd <mbxCommand> CONFIG_PORT, mbxStatus
<mbxStatus>
Adapter initialization failed when issuing a CONFIG_PORT mailbox command.
Data: (1) hbainit
Severity: Error
Log:
Always
Action: This error could indicate a hardware or firmware issue. If this issue persists, report the
error to Technical Support.
0443: Adapter failed to set maximum DMA length mbxStatus <u.mb.mbxStatus>
Cannot set the maximum DMA length to reflect cfg_pci_max_read.
Data: None
Severity: Error
Log:
LOG_INIT
Action: Set module parameter lpfc_pci_max_read to 512, 1024, 2048, or 4096.
0446: Adapter failed to init, mbxCmd <mbxCommand> CFG_RING, mbxStatus
<mbxStatus>, ring <num>
Adapter initialization failed when issuing a CFG_RING mailbox command.
Data: None
Severity: Error
Log:
Always
Action: This error could indicate a hardware or firmware issue. If this issue persists, report the
error to Technical Support.
0447: Adapter failed init, mbxCmd <mbxCommand> CONFIG_LINK mbxStatus
<mbxStatus>
Adapter initialization failed when issuing a CONFIG_LINK mailbox command.
Data: None
Severity: Error
Log:
Always
Action: This error could indicate a hardware or firmware issue. If this issue persists, report the
error to Technical Support.
0448: Adapter failed to init, mbxCmd <mbxCommand> READ_SPARM, mbxStatus
<mbxStatus>
Adapter initialization failed when issuing a READ_SPARM mailbox command.
Data: None
Severity: Error
Log:
Always
Action: This error could indicate a hardware or firmware issue. If this issue persists, report the
error to Technical Support.
Table 4-4 LPFC Error Log Messages and their Descriptions (Continued)