Allnodeinfo, Bindingcapabilities – Dell Emulex Family of Adapters User Manual
Page 408
OneCommand Manager Command Line Interface Version 10.2 User Manual
P010067-01A Rev. A
5. CLI Client Command Descriptions
Persistent Binding Commands
408
In a remote environment, you can perform persistent bindings operations from a host
running any operating system (including Linux or VMware ESXi), but only to a remote
host that is running Windows or Solaris.
For a binding to take effect immediately (that is, SetPersistentBinding parameter: Scope
= I or B), the <SCSIBus> and <SCSITarget> parameters must match the SCSI bus and
SCSI target to which the FC target is already automapped. If automapping is disabled,
the binding takes effect immediately if the FC target is not already persistently bound,
and the specified <SCSIBus> and <SCSITarget> parameters are available to be
persistently bound. Also, the <BindType> parameter must match the currently active
bind type. Otherwise, you are notified that you must reboot the system to cause the
persistent binding to become active.
AllNodeInfo
This command shows target node information for each target accessible by the adapter.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
AllNodeInfo <WWPN>
Parameters
BindingCapabilities
This command shows the binding capabilities of the adapter. If a binding is configured,
it is maintained across reboots.
Supported By
Solaris and Windows
Syntax
BindingCapabilities <WWPN>
Parameters
WWPN
The WWPN of an FC or FCoE port.
WWPN
The WWPN of an FC or FCoE port.