Dell Emulex Family of Adapters - Manual (Page 802)

OneCommand NIC Teaming and VLAN Manager User Manual P009415-01A Rev. A
5. OneCommand NIC Teaming Manager Command Line Interface
The Command Reference
802
Parameters
Description
This command removes the specified adapter from the specified team. The adapter can
only be removed if the team will be left with the minimum number of adapters for that
team type.
Example
c:\Program Files\Emulex\NIC Teaming>octeamcmd.exe delete adapter myteam nic5
Adapter nic5 has been successfully deleted from team FOTeam
Adding a VLAN
The following notes apply to adding a VLAN:

Adapters, teams and VLANs that have been disabled in Network Connections
or Device Manager cannot be managed by the NIC Teaming Manager and may
not be visible to the NIC Teaming Manager. Make sure that any affected
adapters, teams and VLANs are enabled before making any NIC Teaming
configuration changes.

If you use static IP addresses (non-DHCP), you must assign IP addresses to any
native VLANs and VLANs that you create.

When the first VLAN is added to a team, the team's Native VLAN is removed.
The Native VLAN can be added later, if desired. If the Native VLAN is added
again, adding additional VLANs will not affect its state. For more information
about Native VLAN, see “Native VLANs” on page 777.

VLANs created over teams containing non-Emulex team members are not
supported by Emulex. However this configuration may work if the non-Emulex
team members are well-known to your system. Discretion is advised.
Syntax
add vlan <team-id |adapter-id> < vlan-id> {number}
team-id
Team from which an adapter is to be removed.
adapter-id
Adapter to be removed.