Restart the necessary services, Pxe client setup, Figure c-18 – Dell Emulex Family of Adapters User Manual
Page 1751
Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual
P010097-01B Rev. A
Appendix C. Examples for Configuring and Booting UEFI NIC
UEFI NIC IPv6 PXE Setup Procedure for SLES11 SP2
1751
write_enable=YES
listen=NO
listen_ipv6=YES
Restart the Necessary Services
Service nfsserver restart
Service xinetd restart
Service vsftpd restart
Service dhcpd6 restart
PXE Client Setup
To set up the PXE client:
1. Boot the server and press <F2> to enter system setup.
2. Select System BIOS Settings > Boot Settings and change boot mode to UEFI.
3. Reboot the server.
4. Press <F2> to enter system setup.
5. Select System BIOS Settings > Boot Settings > UEFI Boot Settings and set the UEFI
PXE boot protocol to IPv6.
Figure C-18 UEFI Boot Settings Screen
6. Reboot the server.