Dell Emulex Family of Adapters - Manual (Page 1374)

OCM for VMware vCenter Version 10.2 User Manual P009805-01A Rev. A
11. Using OneCommand Manager for VMware vCenter Command Line Interface
The Command Reference
1374
setcablenvp
Note: This command supports only OCe11100 T 10GBASE-T–series adapters.
Syntax
elxvcpcmd.exe v=<vcenter_server> u=<vc_username> p=<vc_password>
h=<esx_host> setcablenvp <WWN | MAC> <NPV>
Description
This command sets the nominal velocity of propagation (N-V-P), required for the TDR
test, for the cable that connects to the physical port associated with the WWPN or
MAC.
Parameters
setcnapgbw
Syntax
elxvcpcmd.exe v=<vcenter_server> u=<vc_username> p=<vc_password>
h=<esx_host> setcnapgbw <WWPN | MAC> <BW0>...<BW7>
Description
This command sets the bandwidth percentage of a priority group on a given FCoE, NIC
or iSCSI port according to the following rules:

Bandwidths BW0 to BW7 must add up to 100%.

Bandwidth can be assigned to a priority group that has priorities.
h
The IP address of the ESXi host with Emulex adapters.
WWPN
The WWPN of a port on the ESXi host with Emulex adapters.
MAC
MAC address of the NIC or iSCSI port.
BeaconState
New state of the beacon:
0 = Off
1 = On
v
The vCenter server IP address.
u
The user name for the vCenter server.
p
The user password for the vCenter server.
h
The IP address of the ESXi host with Emulex adapters.
WWPN
The WWPN of a port on the ESXi host with Emulex adapters.
MAC
The MAC address of the NIC or iSCSI port.
NVP
A percentage value between 1 and 100 (Consult your cable
documentation to obtain the proper NVP value).