Configure boot parameters, Change the device path, Configure boot parameters 0 – Dell Emulex Family of Adapters User Manual
Page 1450: Figure 6-14
Advertising
Boot for the Fibre Channel Protocol User Manual
P010096-01A Rev. A
6. EFIBoot
Configure Boot Parameters
1450
Configure Boot Parameters
The EFI utility enables you to configure the following boot parameters:
Device path
Maximum LUNs per target
Boot target scan
Boot devices
Delay device discovery
To configure boot parameters:
From the EFI – BIOS Setup Utility menu (Figure 6-6), select 3. Configure Boot
Parameters and press <Enter>. The menu shown in Figure 6-14 is displayed.
Figure 6-14 Boot Configuration Menu
Change the Device Path
This option allows you to make the FC driver appear as a SCSI driver. This is useful for
older systems that do not have native support in the EFI system firmware or boot code
for FC device paths.
Advertising