Dell Emulex Family of Adapters - Manual (Page 431)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
Profile Management Commands
431
NPar Enabled — 8 Partitions/Port
>hbacmd cmgetparams 00-00-c9-12-34-56
Active Mode: NPAR
Configured mode: NPAR
Available modes: NPAR
Func# Type MAC Address Min BW Max BW
----- ----- ----------------- ------ ------
0 NIC 00-00-c9-12-34-56 10 50
2 iSCSI 00-00-c9-12-34-57 20 100
4 NIC 00-00-c9-12-34-58 10 50
6 FCoE 00-00-c9-12-34-59 30 100
8 NIC 00-00-c9-12-34-5A 10 50
10 NIC 00-00-c9-12-34-5B 10 50
12 NIC 00-00-c9-12-34-5C 10 50
14 NIC 00-00-c9-12-34-5C 0 50
NParEP Mode
When using NPar adapters, you can change the total number of partitions displayed
and configured on the adapter to 8 when the NParEP Mode property is disabled or to
16 when the NParEP Mode property is enabled. Use the “nparepmode” parameter in
the SetAdapterPortConfig command to enable or disable this property.
Notes:

When NPar is disabled, NParEP Mode is automatically disabled too. It is not
necessary to specify the “nparepmode” parameter on the command line when
disabling NPar by setting the “mctype” parameter to “None”.

After enabling or disabling NParEP Mode with the SetAdapterPortConfig
command, default bandwidths will be automatically assigned to each partition
with an assigned protocol. See “Default NPar Bandwidths” on page 435 for
more information.
Parameters
MAC
MAC address of any iSCSI, NIC or NIC+RoCE partition on the adapter.
WWPN
WWPN of any FCoE partition on the adapter
nparepmode 1 = enable the NParEP Mode to display and configure 16 functions.
0 = disable the NParEP Mode to display and configure 8 functions only.