Grass Valley NV9000-SE v.3.0 - Manual (Page 287)

NV9000-SE Utilities • User’s Guide 267
11. Control Panels
Adding a Control Panel
4 In the ‘Button Layout’ section, select a blank button and then in the ‘Button Definitions’ sec-
tion, select a definition for the button from the drop-down list. The button definition appears on
the selected button in the ‘Button Layout’ section. Buttons in the left-hand section (32 total)
may only be assigned Destination, Level, Salvo, Source and Undefined. The buttons that appear
in the right-hand section (6 total), may be assigned any of the functions listed below.
There are two classes of buttons:
• Those that assign a dedicated function to a button directly, such as ‘Def State’ (default state)
or ‘Clear’.
• Those that define a variable function, such as ‘Destination’. Additional options display
enabling you to define the variables.
Select from the following button options:
5 In the ‘Outputs’ and ‘Inputs’ sections, define the general-purpose I/O (GPIO) connections at the
rear of the control panel as described in Defining General Purpose I/O (GPIO) Connections on
page 337.
Button Modes Description Related Topic
Destination XY only Selects a destination device. Choose a
destination from the drop-down list. An
optional ‘Level Set Filter’ may be selected
to limit the devices that display to only
those in the selected level sets.
Level Sets on page
111
Level XY, MD Shows the status of a specific level on the
display. When a level button is assigned, a
‘Virtual Level’ drop-down menu appears.
Choose one of the levels or ‘none’.
Level Sets on page
111
Name Set Toggle All modes Toggles between the default name set and
the system name set.
Name Set Toggle on
page 363
Panel Lock XY, MD Prevents accidental changes to the control
panel settings. When the control panel is
locked, the button array becomes blank
except for the Panel Lock button.
Panel Lock on page
363
Salvo XY, MD Places the control panel in ‘Salvo’ mode.
The button is required if you want access to
system salvos.
When you assign ‘Salvo’ to a button, a
drop-down list appears in which you select
a salvo ID.
Salvos on page 364
and
Salvos on page 431
Source XY, MD Loads a predefined source device into the
preset column, ready for selection by
pressing Take.
When you assign ‘Source’ to a button, a
drop-down list appears in which you select
a source(s). Select a level from ‘Level Set
Filter’ to limit the sources to only those
assigned to that level. (The same is true if
selecting destinations in multi-destination
mode.)
Source on page 365
Undefined XY, MD Makes the button undefined and inactive. It
will remain unlit. —