Grass Valley NV9000-SE v.3.0 - Manual (Page 432)

412 Rev 3.0 • 25 Mar 10
14. External Interfaces
Adding an External Interface
Figure 14-3. External Interface Page for Serial Protocol
5 The fields display default settings. There are two sections: ‘External Interface Info’ and ‘Exter-
nal Interface Connection Info’. The fields in the ‘External Interface Connection Info’ section
change depending on the protocol selected in step 4.
Update information, as needed:
6 Click
Save
to save your changes.
7 (Optional) Select control point, run condition, run priority, and log mode information using the
‘Apps’ table. See Updating External Interface Information on page 417.
8 Click
X
on the window title tab to close the page.
Section Field Description
External Interface
Info Name The name assigned to the external interface. The information
entered in the ‘Add External Interface’ page displays. You can
change it here at this time.
Params Special parameters to be added for specific functions or to have
special features enabled. For more information, contact Miranda
Technical Support.
External Interface
Connection Info
(displays if Ethernet
protocol selected)
IP Address Enter the IP address for the external interface communication
with the NV9000-SE system.
External Interface
Connection Info
(displays if serial
protocol selected)
Port From the drop-down list, select a port and then select settings
for that port as required.
Note: The serial port settings differ depending on which
protocol was selected in Step 4. The Miranda router standard is
38.4 K baud, 8 data bits, no parity, and 1 stop bit.
Baud Rate
Parity
Stop
Data