Grass Valley NV9000-SE v.3.0 - Manual (Page 388)

368 Rev 3.0 • 25 Mar 10
12. Master Control
Add Master Control
How to Add a Master Control Processor
1 Launch NV9000-SE. (See Launching and Exiting the Application on page 12.)
2 From the navigation area, select the ‘Tasks’ pane and then ‘Add NVision Master Control’. The
‘Add NVision Master Control’ page appears:
Figure 12-1. Add NVision Master Control Page
Red text denotes a required field.
3 Enter a ‘Name’ for the master control processor in the field provided.
4 Select a ‘Router Host’ from the drop-down list. By default, the host assigned to master control
is ‘NVCONFIG’.
5 The ‘Primary Control Point’ (which will be the IP address of the processor on the master con-
trol network) by default is set to ‘New’.
6 Click
Add & Edit
. The ‘Master Control Details’ page appears, as shown in Figure 12-2.
Or
Click
Add & Clear
. The master control processor is added and fields in this page are cleared so
that another master control processor can be added immediately. The master control processor
is added with a default IP address.
Or
Click
Clear
to clear all fields without saving any changes.