Grass Valley NV9000-SE v.3.0 - Manual (Page 392)

372 Rev 3.0 • 25 Mar 10
12. Master Control
Locating and Viewing Master Controls
The ‘Mast Control Details’ page appears:
Figure 12-4. Master Control Details Page
Each section displays specific information, as follows:
S The NV9000 system treats the MCPM or MCE as if it were a router with crosspoints.
4 Click X on the window title tab to close the page.
How to Locate and View Existing Master Controls Using the ‘Routers’ Table
1 Launch NV9000-SE. (See Launching and Exiting the Application on page 12.)
2 From the navigation area, select the ‘Views’ pane and then ‘Routers’. The ‘Routers’ table
appears, as shown in Figure 12-5.
Router Info Name The name assigned the master control processor .
Protocol The protocol used by the master control processor . It is NV
Master Control Ethernet Protocol. (See NV Master Control
Ethernet Protocol on page 515 .)
Router
Connection Info Primary Control
Point The control point must be the IP address of the MCPM or MCE
on the master control network.
Control points (also called control ports) are Ethernet ports in
the NV9000 server through which routers, panels, and other
devices are connected. For more information on control points,
see Managing Control Points on page 381.
Lists ‘IP address’ of connection to control system.