Grass Valley NV9000-SE v.3.0 - Manual (Page 289)

NV9000-SE Utilities • User’s Guide 269
11. Control Panels
Adding a Control Panel
The ‘NV9606’ page appears:
Figure 11-16. NV9606 Page
2 In the ‘Panel Options’ section, select control panel behaviors from the drop-down lists:
3 In the ‘Panel Options’ section, check the ‘Use as Slave Panel’ check box to have the NV9606
act as a “slave” to an NV9607 control panel. For more information, see Default Routing on
page 357.
Button Layout section
Button Definitions section
Panel
Options
section
GPIO section
Field Option Description
Default
Destination
None After a reset, the control panel displays no destination device.
(Not recommended). See Default State on page 356.
‹device› The control panel uses the specified device as the destination after
a reset. This also becomes the destination controlled when the
control panel is set to single destination mode.
Status Monitor None Selected destination used as a monitor to switch the source that is
in ‘status’ mode for the selected destination.
‹device›
High Tally
Illumination ‹number› Controls button brightness. Press the “up” or “down” arrow to
increase or decrease the number that displays. The greater the
number, the greater the brightness; the lower the number, the
dimmer the brightness. High tally is always brighter than low
tally.
Low Tally
Illumination
‹number›