Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 260)

Jog Parameters
Chapter 8
8-2
After you select “Jog Parameters” from the main menu, these screens
become available:
Proj: AMPTEST Appl: AMP Util: Edit
F2-Project F3-Application F4-Utility F5-Configuration F1-File F2-Axis F3-Options F4-Quick Edit! F5-Process
Control Type : Mill Axis : X - linear File : TEST
- Jog Parameters -
Page 2 of 2
Largest Jog Increment (1) : 25.40000 mm
Jog Retract Velocity : 253.9980 mmpm
Max Jogs in Retracts <P1> : 15
Traverse Jog Speed (1) : 3810.00000 mmpm
Proj: AMPTEST Appl: AMP Util: Edit
F2-Project F3-Application F4-Utility F5-Configuration F1-File F2-Axis F3-Options F4-Quick Edit! F5-Process
Control: Mill AXIS : X - linear File : TEST
- Jog Parameters -
Page 1 of 2
Pulse Count Multiplier_Low (1) : 0.00254 mm
Pulse Count Multiplier_Med (1) : 0.02540 mm
Pulse Count Multiplier_High (1): 0.25400 mm
Arbitrary Joggable Axis (1) : True
Lowest Jog Speed (1) : 2.54000 mmpm
Second Jog Speed (1) : 25.40000 mmpm
Third Jog Speed (1) : 253.99998 mmpm
Fourth Jog Speed (1) : 2540.00000 mmpm
Highest Jog Speed (1) : 10159.99980 mmpm
Smallest Jog Increment (1) : 0.00254 mm
Second Jog Increment (1) : 0.02540 mm
Third Jog Increment (1) : 0.25400 mm
Fourth Jog Increment (1) : 2.54000 mm
Use these three pulse-count multiplier parameters to set the resolution of
the hand pulse generator (HPG or handwheel):
Parameter: Page:
Pulse count multiplier — low 8-3
Pulse count multiplier — med 8-4
Pulse count multiplier — high 8-5
The value specified for each of the three pulse-count multiplier parameters
is the distance that the axis moves for each pulse that is sent from the HPG.
These three parameters correspond to LOW X1, MEDL X10, and
MEDX100 of <SPEED/MULTIPLY> on the MTB panel when an HPG jog
is taking place.
Important: When <SPEED/MULTIPLY> is MEDH X1000 or
HIGH X10000, the handwheel is disabled.
The default setting for <SPEED/MULTIPLY> on the pushbutton MTB
panel is LOW X1.
8.1
Pulse Count Multipliers